Zappi - eco-smart charging station for electric vehicles

zappi charger
The Zappi charger allows you to intelligently charge your electric vehicle with the surplus energy from your solar PV system.

It has 3 charge modes, the cleverest being the ECO & ECO+ modes, which maximise the effectiveness of your solar PV system. You can charge your car with the surplus energy your solar system generates.

Fast Charge Mode

In this mode, the vehicle will be charged at maximum power. This is just like an ordinary Mode 3 charging point.

Eco Mode

Charge power is continuously adjusted in response to changes in generation or power consumption elsewhere in the home. Charging will continue until the vehicle is fully charged, even if power is drawn from the grid.

Eco Mode +

Charge power is continuously adjusted in response to changes in generation or power consumption elsewhere in the home. Charging will pause if there is too much imported power, continuing only when there is surplus free power available.

Available As 7kW Single Phase & 22kW 3-Phase

zappi charger
  • Programmable timer function
  • Dynamic load balancing for maximum installation flexibility
  • Pin-code lock function
  • Tap operated display backlight
  • Built-in RCD protection
  • Integral cable holster
  • Charge and event logging
  • Remote control and monitoring add-on option
  • Supplied with clip-on grid current sensor
  • X3 charging modes: eco, eco+ and fast
  • Optimises microgeneration self-consumption
  • 18th edition ready
  • Available in 7kW or 22kW (3-phase)
  • OLEV (Home Scheme) Approved – Hub device required
  • 3 year warranty
Rated Power 7kW (1-ph) or 22kW(3-ph)
Rated Supply Voltage 230V AC Single Phase or 400V AC 3-phase (+/-10%)
Supply Frequency 50 Hz
Rated Current 32A max
Standby Power Consumption 3W
Earth Leakage Protection Integral 30mA Type A RCD (EN 61008) + 6mA DC protection (EN 62955)
Economy Tariff Sense Input 230V AC sensing (4.0kV isolated)
Wireless Interface 868 MHz (proprietary protocol) for wireless sensor and remote monitoring options
Grid Current Sensor 100A max, primary current 16mm max, cable diameter
Cable Entry Rear, bottom or side
Enclosure Dimensions 439 x 282 x 122
Protection Degree IP65 (weatherproof)
Operating Temperature -25°C to +40°C
Circuit Breaker 40A curve B (2-pole 1-ph or 4-pole 3-ph
Earthing Arrangement can be connected to the PME supply. Complies with BS 7671:2018. 722.411 (iii)
TT earth resistance <200 Ω according to BS 7671:2018, or < 100 Ω for some vehicles

Charge Your EV, With The Power From Your PV With Your Zappi